Low Noise Cooling Fan
- For use in equipment racks.
- 95 CFM
- 190 mA / 13 W / 115V
- Ball bearing construction.
- Five blades
- Low noise
D-Ring
- For securing shoulder strapping on large cases
- Can be used as an inexpensive security seal.
Finger Guard
- Mounts externally over the fan.
- Steel grille helps prevent fan blade accidents to fingers.
Fan Panels
- Heavy duty steel (1.5 mm / 16ga.)
- 11 mm / .43" flanges on top and bottom for strength.
- Standard rack width (482 mm / 19")
- Prepunched with vent holes for air circulation.
- Professional black finish.
Neutrik Series "D" Jack Panel
- Heavy duty steel (1.5 mm / 16ga.)
- 11 mm / .43" flanges on top & bottom for strength.
- Standard rack width (482 mm / 19")
- Punched for 12 Neutrik series "D" connections.
- Will accept any Neutrik series "D" connector.
- Fits in a single rack space (44.5 mm / 1.75")
Combination Rack Rail
- Made from heavy duty 2.5 mm / 14ga. steel
- 1956 mm / 77" length (44 rack spaces)
- Prepunched 7.1 mm / .28" holes on front and side for easy mounting of equipment using captive nuts.
- Full hole spacing.
- Conveniently spaced punched, slotted holes for mounting rails to sides of rack.
- Uses robertson bolts or phillips bolt 3/4" x 10-32 bolts, plastic bolts black nylon protection washers, and captive nuts.
- Professional black finish.
Aluminum Blank Panels
- Made from heavy duty aluminum (2 mm / 14ga.)
- Available in nine sizes to fit one to nine rack spaces.
- 13 mm / .50" flanges on top and bottom for extra strength.
Standard Rack Rail
- Made from heavy duty 2.5 mm / 12 ga. steel.
- 1867 mm / 73.5" length (42 rack spaces)
- Pretapped with 10-32 holes for mounting equipment.
- Prepunched with 6.3 mm / .25" holes for mounting to sides of rack.
- Professional Black finish
- Uses robertson bolt or robertson bolt 3/4" x 10-32 bolts and plastic washer black nylon protection washers.
 |
 |
 |